JC pro1000S logic baseband eeprom ic for Iphone 6S 6SP 7 7P IPad

Comments

Post a Comment

Popular posts from this blog

How to Fix iPhone 6s Plus Charging Issue - Look Here!

Image
The charging problem can divided into many different situations: the iPhone battery power percentage is getting less during the charging, power down status can be charged successfully but cannot charge after boot and unable to recognize USB, etc. First ,we check iPhone schematic diagram on WUXINJI Dongle , we found that the PP5V0_USB(5.0V) that was sent from the iPhone Tail Plug circuit, and then continue sent to the charging IC via the trailing plug interface, and then go through the charging protect tube, finally send it to iPhone USB control IC. After disassemble the iPhone by phone opening tools, remove the iPhone motherboard, use Fluke 15B+Digital Multimeter to measure the 5.0V voltage (PP5V0_USB) next to the charging IC, and then measure the 5.0V voltage (PP5V0_USB) next to the USB control IC to check is it working properly. If both these 5.0V is working properly, then you just need replace the iPhone charging IC and USB control IC. If 5.0V(PP5V0_U...
Read more

How to Settle Yanhua FEM key Programmer Input Program Mode Error

Image
If you buy Yanhua BMW FEM BDC key Programmer, but when you encounter a lot of mistakes in the use of the process, it is possible that you do not follow the programmer's advice and instructions, so the input pattern error, VIP Pro Shop Team will today to share some of the most effective methods to you, following this article: There are 2 tips to read out 95128/95256 data: 1. After you are taken to step2: update/program FEM/BDC, you get the message “Please disconnect the vehicle battery, remove the FEM/BDC module, use Yanhua FEM key programmer read and save 95128/95256 EEPROM original data”. Then please make sure you do as it says, just read out the 95128/95256 data and backup it, for example, please name 95128/95256 data as “EEPROM_95XXX.bin”. 2. After you are taken to this step shown as below, choose the “EEPROM_95XXX.bin”(the 95128/95256 datasaved in the previousstep).  Note: it you selected the 95128/95256 data that you back up before, then you may ...
Read more

iPhone 6S won't turn on after drop into water - HERE FIX!

Image
Today, a customer brought his iPhone6S, hope we can help him, his iPhone 6S accidentally drop into water, and then the iPhone 6S won't turn on anymore, how to fix it? Here is the guide!  Disassemble the iPhone 6S by phone opening tools, connect iPhone motherboard to the DPS DC power supply, it leaks 120mA, after triggering, the current is stuck in 360mA.  Remove the iPhone motherboard, and observe it, we found the iPhone baseband power IC, NFC IC, iPhone big audio IC and iPhone display power IC all have traces of water. Clean up the iPhone motherboard with iPhone PCB cleaner, and then connect it to the DC power supply again to observe the current, now the current turns to 80mA, after triggering, the current is stuck in 300mA. At the same time, we found the iPhone display power IC was repaired before, and the corner of iPhone display power IC was damaged. Remove the iPhone display power IC, re-connect to DC power supply , the iPhone motherboard is no lon...
Read more